LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 910 (Anti-Lock Brake System -- F250-F550 Super Duty) >> Removal & Installation >> Wheel Speed Sensor - Front, 4X2 >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the front wheel speed sensor electrical connector.
  3. Separate the wheel speed sensor harness from the brake hose clips.
    Fig 1: Separating Wheel Speed Sensor Harness From Brake Hose Clips
    G03924226Courtesy of FORD MOTOR CO.
  4. Remove the bolt and the front wheel speed sensor.
    Fig 2: Removing Bolt & Front Wheel Speed Sensor
    G03924227Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals