LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (Steering System - General Information -- F250-F550 Super Duty) >> Diagnosis And Testing >> Steering System >> Pinpoint Tests >> Pinpoint Test B: Steering Is Very Difficult/Very Easy

Pinpoint Test B: Steering Is Very Difficult/Very Easy

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1 CHECK THE STEERING COLUMN BEARINGS AND THE INTERMEDIATE SHAFT 
    NOTE: Be sure to keep the clockspring centered when disconnecting the intermediate shaft. Refer to SUPPLEMENTAL RESTRAINT SYSTEM .
    • Check the steering column and intermediate shaft for grounding.
    • Disconnect the steering column intermediate shaft at the steering column.
    • Verify that the intermediate shaft U-joints do not bind and that the steering column bearing rotates freely.
    • Are the steering column bearing and intermediate shaft U-joints OK? 
    • Yes  : GO to B2.
    • No  : If the steering column or the intermediate shaft are grounding, REPAIR as necessary. TEST the system for normal operation.

    If the steering column bearings or the intermediate shaft are binding, INSTALL a new intermediate shaft or steering column. REFER to STEERING COLUMN . TEST the system for normal operation.

  2. B2 CHECK THE FRONT BALL JOINTS 
  3. B3 MONITOR ENGINE RPM CHANGES 
    NOTE: Make sure the vehicle is on a flat, dry surface.
    • Key in START position.
    • CAUTION: Do not hold the steering wheel at the stops for an extended amount of time. Damage to the power steering pump can occur.
    • Turn the steering wheel once to the left stop position and then to the right stop position.
    • Note the engine rpm during the turns.
    • Does the engine rpm change when turning the steering wheel? 
    • Yes  : If no power steering assist is present and the engine rpm changes, INSTALL a new steering gear. REFER to POWER STEERING .

      If left-to-right variation is present, INSTALL a new steering gear. REFER to POWER STEERING .

      If no power steering assist is present and the engine rpm does not change, INSTALL a new power steering pump. REFER to POWER STEERING .

      If excessive effort is required in one or both directions, INSTALL a new power steering pump. REFER to POWER STEERING . TEST the system for normal operation.

    • No  : CARRY OUT the Pump Flow and Pressure Test. REFER to COMPONENT TESTS . TEST the system for normal operation.