LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Electronic Engine Control System -- Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Oil Temperature Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Drain the engine oil.
  4. Disconnect the EOT sensor electrical connector.
  5. Remove the EOT sensor. Discard the O-ring seal.
    • To install, tighten to 15 Nm (11 lb-ft).
    • Install a new O-ring seal. Lubricate the new O-ring seal with clean engine oil prior to installation.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals