LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 895 (Electronic Engine Control System -- Gasoline Engines -- F250-F550 Super Duty) >> Removal And Installation >> Intake Manifold Runner Control (IMRC) Actuator - 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the air cleaner outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
  3. Disconnect the intake manifold runner control (IMRC) actuator electrical connector.
  4. Remove the 3 bolts.
    • To install, tighten to 6 Nm (53 lb-in).
  5. Disconnect the IMRC rod pivot pin from the intake manifold rod and remove the IMRC.
    • Lubricate the IMRC rod pivot pin with clean engine oil prior to installation.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals