LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Controls - Removal, Overhaul & Installation) >> Fuel Systems >> Fuel Injection Supply Manifold & Injectors >> Removal & Installation (3.0L)

Removal & Installation (3.0L)

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE . Remove upper intake manifold and throttle body assembly. See REMOVAL & INSTALLATION (3.0L - UPPER)  under INTAKE MANIFOLD under AIR INDUCTION SYSTEMS.
  2. Disconnect fuel line. See FUEL LINE CONNECTORS . Disconnect fuel injector connectors. Remove 4 fuel injection supply manifold bolts. Remove fuel injection supply manifold and injectors. Remove injectors from fuel rail by using a rocking motion and discard "O" rings.
  3. To install, lubricate NEW "O" rings with clean engine oil. DO NOT use silicone grease. Ensure injectors are fully seated in lower intake manifold. Install 4 fuel injection supply manifold bolts and tighten to specification. See TORQUE SPECIFICATIONS . Connect fuel injector wiring harness. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals