LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Controls - Removal, Overhaul & Installation) >> Evaporative Emissions System >> Charcoal Canister >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove spare tire. Disconnect negative battery cable. Raise and support vehicle. Disconnect EVAP canister purge outlet tube and harness connector. Remove nuts and bolt retaining EVAP canister bracket assembly and remove EVAP canister bracket assembly. Disconnect hoses and connectors. Remove canister vent solenoid. Remove EVAP canister purge sleeve.
    2. CAUTION: Use "O" rings made of fuel-resistant material. Use of ordinary "O" rings can cause fuel system to leak. DO NOT reuse "O" rings.
    NOTE: Lubricate NEW "O" rings with clean engine oil to aid installation.
  2. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Ensure EVAP system does not leak. Perform after repair procedure. See AFTER REPAIR PROCEDURE .
scientia non olet · About LEMON Manuals