LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Controls - Removal, Overhaul & Installation) >> Emission Systems & Subsystems >> Positive Crankcase Ventilation Valve >> Removal & Installation (2.3L)

Removal & Installation (2.3L)

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Remove left front wheel and tire. Remove electrical connector locators from left side inner fender well splash shield. Remove screws, push pin and bolts from splash shield and remove splash shield. Disconnect coolant by-pass hose from routing clip. Gently pry Positive Crankcase Ventilation (PCV) valve cap off 2 tabs and remove PCV valve from crankcase vent oil separator and disconnect vacuum hose. To install, reverse removal procedure.

scientia non olet · About LEMON Manuals