LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Controls - Removal, Overhaul & Installation) >> Air Induction Systems >> Intake Manifold Runner Control Actuator (2.3L Only) >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Disconnect Intake Manifold Runner Control (IMRC) actuator electrical connector and vacuum lines. Remove bolt and IMRC actuator. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals