Rear Brake Caliper Anchor Plate: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Position the brake caliper anchor plate and install the 2 brake caliper anchor plate bolts.
- For F-250, F-350 single rear wheel caliper, tighten to 275 Nm (203 lb-ft).
- For F-350 dual rear wheel caliper, tighten to 275 Nm (203 lb-ft).
- For F-450, F-550 dual rear wheel caliper, tighten to 400 Nm (295 lb-ft).
  
  Fig 1: Positioning Brake Caliper Anchor Plate And Installing 2 Brake Caliper Anchor Plate Bolts
  Courtesy of FORD MOTOR CO.
Install the brake pads. For additional information, refer to BRAKE CALIPER .