Height Adjuster - Shoulder Safety Belt: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed, install a new shoulder safety belt guide.

Fig 1: Locating Front Seat Belt Guide Cover

Courtesy of FORD MOTOR CO.

Remove the front shoulder safety belt guide cover (60262).
Remove the shoulder safety belt guide.
1. Remove the shoulder safety belt guide nut.
2. Remove the shoulder safety belt guide.
  
  Fig 2: Removing Shoulder Safety Belt Guide
  Courtesy of FORD MOTOR CO.
On the driver side, remove the body side trim finish panel and the front upper body side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION . .
On the passenger side, remove the center body pillar upper trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION
Remove the height adjuster cover (602B90).

Fig 3: Removing Height Adjuster Cover
Courtesy of FORD MOTOR CO.
Remove the shoulder safety belt height adjuster (602B82).
1. Use the Safety Belt Bolt Torx Bit to remove the bolts.
2. Remove the shoulder safety belt height adjuster.
  
  Fig 4: Removing Shoulder Safety Belt Height Adjuster
  Courtesy of FORD MOTOR CO.