Safety Belt Tongue Rotated on Belt

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Safety Belt Tongue Rotated On Belt

Courtesy of FORD MOTOR CO.

Grasp the belt tongue and pull down on the closest belt webbing to form a loop through the upper (narrower and longer) slot in the tongue.

Fig 2: Pulling Closest Belt Webbing
Courtesy of FORD MOTOR CO.
Working within the upper slot, rotate and fold the belt webbing over itself as required to remove the twist.
Pull the excess belt webbing back through the upper slot in the tongue.
Repeat Steps 1- 3 to complete the removal of the twist at the lower (wider and larger) slot in the tongue.

Fig 3: Removing Twist At Lower (Wider And Larger) Slot In Tongue
Courtesy of FORD MOTOR CO.
When completed, the safety belt should look like Fig 4.

Fig 4: View Of Safety Belt
Courtesy of FORD MOTOR CO.