LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Knock Sensor >> Removal & Installation (2.0L)

Removal & Installation (2.0L)

WARNING: This page is about a different car, the 2002 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Disconnect knock sensor harness connector, located on right side of engine block. Remove sensor nut and knock sensor. To install, reverse removal procedure. Tighten knock sensor nut to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals