Seat - Rear, Quad Bucket: Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Position the rear bucket seat in the vehicle.
From the passenger side, insert the four pins in the seat support into the four holes in the seat striker.

Fig 1: Inserting Four Pins In Seat Support Into Four Holes In Seat Striker
Courtesy of FORD MOTOR CO.
Rotate the handle downward and in as far as it will go, to lock the rear bucket seat in place.

Fig 2: Locking Rear Bucket Seat In Place
Courtesy of FORD MOTOR CO.
Make sure the safety belt is not twisted, then insert the safety belt tongue into the detachable anchor until you hear a "click" and feel the latch engage.