Removal & Installation
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Raise and support vehicle. Remove A/C compressor to gain access. Disconnect Crankshaft Position (CKP) sensor wire connector from engine harness. See Fig 1. Remove CKP sensor mounting screws. Remove CKP sensor. To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .