LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Engine Controls - Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Gasoline) >> Ignition Systems >> Camshaft Synchronizer >> Installation

Camshaft Synchronizer: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure crankshaft is still at TDC No. 1 compression stroke. Install synchro positioning tool on camshaft synchronizer by rotating tool until it engages notch in camshaft synchronizer housing.
    NOTE: During installation, arrow on synchro positioning tool will rotate clockwise as gears engage.
  2. Install camshaft synchronizer so arrow on synchro positioning tool is 54 degrees from centerline of engine. See Fig 1. Install camshaft synchronizer retaining bolt.
  3. Remove synchro positioning tool. Install camshaft position senor. To complete installation, reverse removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Aligning Camshaft Synchronizer
G97F03652Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals