LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 826 (HVAC System - Air Conditioning) >> Removal And Installation >> Air Conditioning (A/C) Cycling Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

    4.6L, 5.4L and 6.8L vehicles 

  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the battery.

    3. All vehicles 

  3. Disconnect the A/C cycling switch connector.
    Fig 1: Disconnecting A/C Cycling Switch Connector
    G03890160Courtesy of FORD MOTOR CO.
  4. Remove the A/C cycling switch (19E561) from the top of the suction accumulator/drier (19C836).
    Fig 2: Removing A/C Cycling Switch From Top Of Suction Accumulator/Drier
    G03890161Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
    • Install a new O-ring seal lubricated in clean mineral oil.
      Fig 3: Installing O-Ring Seal
      G03890162Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals