LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Removal, Overhaul & Installation) >> Ignition Systems >> Crankshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Mercury Grand Marquis, 2002 Lincoln Town Car, and 2002 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Position Sensor (CKP) sensor is located on front cover near crankshaft pulley. Disconnect negative battery cable. Remove serpentine drive belt. Raise and support vehicle. Remove splash shields as necessary to access CKP sensor. Unbolt and move aside A/C compressor.
  2. Disconnect wiring from CKP sensor. Remove CKP sensor bolt and CKP sensor. To install, reverse removal procedure. Tighten CKP sensor bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals