LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 815 (Automatic Transmission - 5R110W) >> Disassembly And Assembly Of Subassemblies >> Forward GEARTRAIN Assembly - Assembly >> Assembly

Forward GEARTRAIN Assembly - Assembly: Assembly

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the forward clutch assembly into the direct clutch assembly.
    Fig 1: Installing Forward Clutch Assembly Into Direct Clutch Assembly
    G03889476Courtesy of FORD MOTOR CO.
  2. Install the No. 9 forward clutch bearing.
    Fig 2: Installing No. 9 Forward Clutch Bearing
    G03889477Courtesy of FORD MOTOR CO.
  3. Install the forward hub and ring gear assembly.
    Fig 3: Installing Forward Hub And Ring Gear Assembly
    G03889478Courtesy of FORD MOTOR CO.
  4. Install the planet carrier and bearing assembly.
    Fig 4: Installing Planet Carrier And Bearing Assembly
    G03889479Courtesy of FORD MOTOR CO.
  5. Install the No. 12 thrust bearing onto the forward carrier assembly.
    Fig 5: Installing No. 12 Thrust Bearing Onto Forward Carrier Assembly
    G03889480Courtesy of FORD MOTOR CO.
  6. Install the input shell assembly.
    • Make sure the tab is engaged in the forward clutch assembly.
      Fig 6: Installing Input Shell Assembly
      G03889481Courtesy of FORD MOTOR CO.
  7. Install the special tools. Position aside to use during transmission assembly.
    Fig 7: Installing Special Tools
    G03889482Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals