LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Automatic Transmission - 4R70W, 4R75W) >> In-Vehicle Repair >> Reverse Servo Assembly >> Removal

Reverse Servo Assembly: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the main control valve body. For additional information, refer to MAIN CONTROL VALVE BODY .
  2. Using the special tool, remove the reverse band servo retaining ring.
    1. Compress the servo spring.
    2. Remove the reverse band servo retaining ring.
      Fig 1: Removing/Installing Reverse Band Servo Retaining Ring Using Special Tool
      G03963989Courtesy of FORD MOTOR CO.
  3. Remove the reverse servo assembly.
    1. Remove the reverse band servo cover.
    2. Remove the reverse band servo piston and rod.
    3. Remove the reverse band servo spring.
      Fig 2: Removing Reverse Band Servo Piston And Rod
      G03888636Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals