LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 814 (Automatic Transmission - 4R70W, 4R75W) >> In-Vehicle Repair >> Digital Transmission Range (Tr) Sensor >> Removal

Digital Transmission Range (Tr) Sensor: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING for E-series, or JACKING & LIFTING - F150 PICKUP .
  2. Disconnect the digital TR electrical connector.
  3. Disconnect the shift cable end.
    Fig 1: Identifying Manual Control Lever Shift Cable End
    G03888604Courtesy of FORD MOTOR CO.
  4. Remove the manual control lever.
    1. Remove the manual control lever nut.
    2. Remove the manual control lever.
      Fig 2: Removing Manual Control Lever Nut
      G03888526Courtesy of FORD MOTOR CO.
  5. Remove the digital TR sensor.
    1. Remove the two retaining bolts.
    2. Remove the TR sensor.
      Fig 3: Removing Two Retaining Bolts
      G03888606Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals