LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 812 (Electronic Engine Controls - Gasoline Engines) >> Removal And Installation >> Camshaft Position (CMP) Sensor - 4.6L, 5.4L, 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the camshaft position (CMP) sensor electrical connector.
    Fig 1: Disconnecting Camshaft Position (CMP) Sensor Electrical Connector
    G03888351Courtesy of FORD MOTOR CO.
  3. Remove the bolt and the CMP sensor.
    Fig 2: Removing Camshaft Position Sensor
    G03888352Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals