LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 808 (Engine Emission Control 6.0L (99P E-Series)) >> Removal And Installation >> Differential Pressure Feedback Exhaust Gas Recirculation (EGR) System - 5.4L (2V) >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the engine cover. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Remove the differential pressure feedback exhaust gas recirculation (EGR) system.
    1. Disconnect the electrical connector.
    2. Disconnect the hoses.
    3. Remove the bolts.
      Fig 1: Disconnecting Electrical Connector
      G03888301Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals