Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the cooling fan stator. For additional information, refer to COOLING FAN STATOR - 6.0L DIESEL .
Remove the accessory drive belt.

Fig 1: Rotating Accessory Drive Belt Tensioner Clockwise
Courtesy of FORD MOTOR CO.
Remove the bolts and the coolant pump pulley.

Fig 2: Removing Coolant Pump Pulley Bolts
Courtesy of FORD MOTOR CO.
Remove the bolts and the coolant pump.
- Remove and discard the O-ring seal.
  
  Fig 3: Removing Coolant Pump Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Clean and inspect the coolant pump mounting.