LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 798 (Engine - 6.8L- E350 & E450) >> In-Vehicle Repair >> Camshaft >> Removal

In-Vehicle Repair: Camshaft: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the timing drive components. For additional information, refer to TIMING DRIVE COMPONENTS .
  2. Use the special tool to compress the valve springs and remove the camshaft roller followers.
    Fig 1: Compressing Valve Springs
    G04002269Courtesy of FORD MOTOR CO.
    3. CAUTION: The bearing caps must be marked for installation in their original location or engine damage can occur.
    Fig 2: Removing Bolts
    G03886490Courtesy of FORD MOTOR CO.
  3. Remove the bolts, the camshaft bearing caps and the camshaft from the cylinder block.
scientia non olet · About LEMON Manuals