Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, and 2005 Ford E450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.

NOTE: Prior to removal of the module, it is necessary to upload module configuration information to the diagnostic tool, this information needs to be downloaded into the new module once installed. For additional information, refer to MODULE CONFIGURATION .

Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
Remove the audio unit. For additional information, refer to AUDIO UNIT .
Remove the headlamp switch knob.
1. Remove the headlamp switch knob.
2. Rotate the headlamp switch bezel counterclockwise and remove.
  
  Fig 1: Removing Headlamp Switch Knob
  Courtesy of FORD MOTOR CO.
Remove the instrument panel finish panel.
1. Remove the bolts.
2. Remove the instrument panel finish panel.
  - Disconnect the electrical connectors.
    
    Fig 2: Removing Instrument Panel Finish Panel
    Courtesy of FORD MOTOR CO.
Remove the instrument cluster.
1. Remove the bolts.
  - Remove the transmission range indicator and disconnect the electrical connectors.
2. Remove the instrument cluster.
  
  Fig 3: Removing Instrument Cluster
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.