LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 777 (Rear Drive Axle/Differential - Ford 8.8-Inch Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Removal

Drive Pinion Seal: Removal

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pinion flange. For additional information, refer to DRIVE PINION FLANGE .
  2. Using a screwdriver, force the metal flange of the rear axle drive pinion seal up and strike it with a hammer.
    Fig 1: Forcing Up Rear Axle Drive Pinion Seal Metal Flange
    G03883979Courtesy of FORD MOTOR CO.
  3. Install gripping pliers and remove the seal.
    Fig 2: Removing Drive Pinion Seal
    G03878521Courtesy of FORD MOTOR CO.
  4. Discard the seal.
scientia non olet · About LEMON Manuals