Removal and Installation

WARNING: This page is about a different car, the 2005 Ford RV Cutaway, 2005 Ford Econoline, 2005 Ford E450 Super Duty, and 2005 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear stabilizer bar.
1. Remove the lower nut, washer and insulator.
2. Remove the upper bolt and washer.
3. Remove the rear stabilizer bar.
  
  Fig 1: Identifying Loosening Torque Of Rear Stabilizer Bar Bolt
  Courtesy of FORD MOTOR CO.
Remove the bolt and the stabilizer bar.
- Discard the bolts.
  
  Fig 2: Identifying Loosening Torque Of Stabilizer Bar Bolts
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.