Removal & Installation (Escape - 4WD)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Ford Ranger, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Explorer Sport Trac. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect Vehicle Speed Sensor (VSS) harness connector. See Fig 1. Remove retaining bolt and VSS. See Fig 2. To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .

Fig 1: Locating Vehicle Speed Sensor Connector (Escape - 4WD)

Courtesy of FORD MOTOR CO.

Fig 2: Identifying Vehicle Speed Sensor Retaining Bolt (Escape - 4WD)

Courtesy of FORD MOTOR CO.