Analyzing Data from Playback of Stored PIDs
Look for abnormal events or values that are clearly incorrect. Inspect the signals for abrupt or unexpected changes. For example, during a steady cruise most of the sensor values should be relatively stable. Sensors such as throttle position (TP), mass air flow (MAF), and RPM that change abruptly when the vehicle is traveling at a constant speed are clues to a possible fault area.
Look for an agreement in related signals. For example, if TP is changed during acceleration, a corresponding change should occur in idle air control (IAC), RPM, and SPARK ADV PID.
Make sure the signals act in proper sequence. An increase in RPM after the TP is increased is expected. However, if the RPM increases without a TP change, a fault may exist.
Table Format (Fig 1): Scroll through the PID data while analyzing the information. Look for sudden drops or spikes in the values. (Refer to the following TP example). Notice the major jump in the TP voltage while scrolling through the information. This example would require a smooth and progressive accelerator pedal travel during a key on and engine off mode.
Graph Format (Fig 2): Scroll through the PID data while analyzing the information. Look for sudden drops or spikes in the linear lines showing the transformation of values to the line graph. This example would require smooth progressive accelerator pedal pressure with the key on and the engine off.