LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P0723 - Output Shaft Speed Sensor Circuit Intermittent Failure

P0723 - Output Shaft Speed Sensor Circuit Intermittent Failure

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0723 - OUTPUT SHAFT SPEED SENSOR CIRCUIT INTERMITTENT FAILURE

Description:  The output shaft speed sensor signal to the PCM is irregular or interrupted.
Possible Causes: 
  • Harness connector not properly seated.
  • Harness intermittently shorted or open.
  • Harness connector damaged.
  • OSS sensor damaged, or not installed properly.
Diagnostic Aids: 
  • Verify harness and connector integrity.
  • Verify OSS sensor proper installation.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
Manual Transmission - - GO to TJ: Output Shaft Speed (OSS) Sensor Introduction STEP 1
All Others - - Go to the appropriate AUTOMATIC TRANSMISSION article.
scientia non olet · About LEMON Manuals