LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 753 (Engine Controls - Powertrain DTC Charts & Descriptions - CNG, Flex-Fuel & Gasoline) >> Diagnostic Trouble Code (DTC) Charts >> P0127: Intake Air Temperature Too High

P0127: Intake Air Temperature Too High

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2004 Mercury Sable, 2004 Mercury Mountaineer, 2004 Mercury Monterey, 2004 Mercury Marauder, and 2004 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0127 - INTAKE AIR TEMPERATURE TOO HIGH

Description:  Indicates that the IAT2 sensor has detected a potential abnormality in the intercooler system. This condition will cause the boost from the supercharger to be bypassed to avoid potential engine damage.
Possible Causes: 
  • Blockage of heat exchangers.
  • Low fluid level.
  • Fluid leakage.
  • Intercooler pump or relay failure.
  • Crossed intercooler coolant lines.
Diagnostic Aids:  Monitor IAT2 PID. Typical IAT2 temperature should be greater than IAT1. REFER to REFERENCE VALUES - CNG, FLEX-FUEL & GASOLINE .
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to PINPOINT TEST DU: INTAKE AIR TEMPERATURE 2 SENSOR Step 7.