LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 746 (Engine Controls - Diagnostic Subroutines - 6.0L Diesel (99P E-Series & 99P F450/550)) >> Hard Start/No Start Diagnostic Procedures >> 11. Glow Plug System Operation >> Recommended Procedure:

Recommended Procedure:

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, and 2004 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Check for poor connections or loose fitting pins.
NOTE: Incorrect measurements will result if all glow plug connectors are not disconnected.

The glow plug monitor self-test is a KOER functional test of the glow plug system. The self-test is performed on-demand with the engine running and the A/C off. The PCM will activate the GPCM which monitors the glow plugs. The pedal may be used to increase the engine speed to increase voltage if needed. For fault detection, the self-test requires a fault present at the time of testing.

Fig 1: Glow Plug Circuit Diagram
G03467772Courtesy of FORD MOTOR CO.