LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Automatic Transmission - Diagnosis - 4R100) >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes (Quick Test) >> EEC-IV 104-Pin Breakout Box

EEC-IV 104-Pin Breakout Box

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, 2001 Ford RV Cutaway, and 2001 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

If instructed, disconnect PCM harness connector. Inspect connector for damaged terminals, corrosion and loose wires. Repair as necessary. Install Breakout Box (418-049), leaving PCM disconnected. Breakout box is used to assist in performing voltage and resistance measurements at PCM harness connector without damage to connector. Breakout box may be also know as the BOB.

scientia non olet · About LEMON Manuals