LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Automatic Transmission - Diagnosis - 4R100) >> Self-Diagnostic System >> Output State Control Modes >> Notes

Output State Control Modes: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Lincoln Navigator, 2002 Ford Expedition, 2001 Lincoln Navigator, 2001 Ford RV Cutaway, and 2001 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: TR sensor and VSS must be operational to enter OSC modes. No DTCs may be present for TR and VSS sensors before entering OSC modes.

OSC modes allow control of some parameters for specific operation. OSC has 2 modes of operation: Bench Mode and Drive Mode. Each mode has a unique set of vehicle operation requirements that must be met before OSC operation will be allowed. If vehicle requirements are not met, an error message will be displayed and OSC mode will be aborted. Follow OSC PRELIMINARY PROCEDURES  before entering into OSC modes.