LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 729 (Engine - 6.0L Diesel - F250-F550 Super Duty) >> In-Vehicle Repair >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the gears with marks pointing outward.
    Fig 1: Identifying Inner And Outer Oil Pump Drive Rotors With Alignment Marks
    G03887281Courtesy of FORD MOTOR CO.
  1. Lubricate the inner gear with lithium assembly grease and install onto the crankshaft. Lubricate the outer gear with lithium assembly grease and mesh with the inner gear rotor in the oil pump housing. Wipe off the excess assembly grease.
    2. NOTE: Install a new O-ring seal.
    Fig 2: Installing Gerotor Cover Bolts
    G03899519Courtesy of FORD MOTOR CO.
  2. Install the gerotor cover and bolts.
  3. Install the crankshaft front oil seal. For additional information, refer to CRANKSHAFT FRONT SEAL .
scientia non olet · About LEMON Manuals