LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 729 (Engine - 6.0L Diesel - F250-F550 Super Duty) >> In-Vehicle Repair >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    CAUTION: To prevent engine damage, you must always install 4 new bolts when installing the vibration damper.
    NOTE: Do not use anti-seize compounds, grease or any lubricants. Lubricants have an adverse effect on the torque results.
    NOTE: To prevent the crankshaft vibration damper from turning during tightening, install 2 bolts in the outer crankshaft vibration damper bolt holes and hold with a pry bar.
    Fig 1: Installing Crankshaft Vibration Damper Bolts
    G03899201Courtesy of FORD MOTOR CO.
  1. Install the crankshaft vibration damper and bolts.
    • Tighten in the sequence shown.
    • Tighten to 68 N.m (50 lb-ft).
    • Tighten an additional 90 degrees.
  2. Install the accessory drive belt.
    Fig 2: Rotating Accessory Drive Belt Tensioner
    G03906750Courtesy of FORD MOTOR CO.

    3. Vehicles with dual generator 

  3. Install the dual generator pulley and bolts.
    Fig 3: Installing Dual Generator Pulley Bolts
    G03899203Courtesy of FORD MOTOR CO.
  4. Install the dual generator accessory drive belt.
    Fig 4: Rotating Drive Belt Tensioner Clockwise
    G03887086Courtesy of FORD MOTOR CO.

    5. All vehicles 

  5. Install the cooling fan stator - 6.0L diesel engine. For additional information, refer to ENGINE COOLING .
  6. Connect the LH and RH battery ground cables.
scientia non olet · About LEMON Manuals