LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 727 (Automatic Transmission - 5R110W) >> Diagnosis & Testing >> Transmission Drive Cycle Test >> After On-Board Diagnostics

After On-Board Diagnostics

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The vehicle wiring harness, powertrain control module (PCM) and non-transmission sensors can affect transmission operations. Repair these concerns first.

After the On-Board Diagnostics procedures are completed, repair all DTCs.

Always repair all non-transmission-related DTCs first, then repair any transmission-related DTCs. Refer to the DIAGNOSTIC TROUBLE CODE CHART  for information on condition and symptoms. This chart will be helpful in referring to the correct manual(s) and to aid in diagnosing internal transmission concerns and external non-transmission inputs. The pinpoint tests are used in diagnosing electrical concerns of the transmission. Make sure the vehicle wiring harness and the PCM are diagnosed as well. The Powertrain Control/Emissions Diagnosis (PC/ED) manual will aid in diagnosing non-transmission-related electronic components.

scientia non olet · About LEMON Manuals