LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 726 (Engine 6.0L Diesel (99P E-Series & 99P F450/550)) >> In-Vehicle Repair >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the gears with marks pointing outward.
    Fig 1: Installing Gears With Marks Point
    G02764524Courtesy of FORD MOTOR CO.
  1. Lubricate the inner gear with lithium assembly grease and install onto the crankshaft. Lubricate the outer gear with lithium assembly grease and mesh with the inner gear rotor in the oil pump housing. Wipe off the excess assembly grease.
    2. NOTE: Install a new O-ring seal.
    Fig 2: Installing Gerotor Cover And Bolts
    G02764525Courtesy of FORD MOTOR CO.
  2. Install the gerotor cover and bolts.
  3. Install the crankshaft front oil seal. For additional information, refer to CRANKSHAFT FRONT SEAL .
scientia non olet · About LEMON Manuals