PCM Reset
WARNING: This page is about a different car, the 2001 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
After a PCM reset procedure, the following conditions will be met:
- All DTCs cleared from PCM memory.
- All freeze frame data cleared from PCM memory.
- All oxygen sensor test data cleared from PCM memory.
- OBD-II system monitor status is reset.
- DTC P1000 set in PCM memory.
To perform PCM reset using scan tool, ensure connectors are properly connected. Program scan tool following manufacturers instructions. Follow operating instructions from scan tool menu.
All DTCs should now be cleared from PCM memory. If concern has not been corrected or fault is still present, hard fault will immediately be reset in PCM memory.