LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Handles, Locks, Latches & Entry Systems -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Keyless Entry Keypad >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to all Excursion and F-Super Duty vehicles built after 12/03.
NOTE: On F-Super Duty vehicles built before 12/03, the wireless keyless entry keypad uses a self-adhesive material to attach it to the driver door. No wiring harness disconnect is necessary.
  1. Disconnect the battery. Refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the front door trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Position the watershield aside.
  4. Disconnect the keypad electrical connector.
    • Release the harness pin-type retainers.
  5. Remove the keyless entry keypad and harness.
    1. Remove the clip.
    2. Remove the keyless entry keypad and harness.
      Fig 1: Removing Keyless Entry Keypad And Harness
      G02774498Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals