LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Handles, Locks, Latches & Entry Systems -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Door Latch Remote Control - Rear SuperCab >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door trim panel. Refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
    3. CAUTION: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed a 6.25 mm (.25 in) drill bit.
  3. Remove the rear door latch remote control.
    1. Disconnect the necessary actuating rods and cables.
    2. Remove the rivets.
    3. Remove the rear door latch remote control.
      Fig 1: Removing Rear Door Latch Remote Control
      G02774475Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals