LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Handles, Locks, Latches & Entry Systems -- Excursion & F250-F550 Super Duty) >> Diagnosis And Testing >> Locks, Latches and Entry Systems - Module Controlled >> Principles of Operation >> Autolock Enable/Disable - Using the Ignition Switch

Autolock Enable/Disable - Using the Ignition Switch

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Another way to turn the autolock feature off/on is by following this series of steps:

  1. Close all doors.
  2. Confirm that the key is in the OFF position.
    3. NOTE: Steps 3 through eight must be carried out within 30 seconds.
  3. Turn the key from OFF to RUN.
  4. Press UNLOCK 3 times.
  5. Turn the key from RUN to OFF.
  6. Press UNLOCK 3 times.
  7. Turn the key from OFF to RUN. The enable/disable mode is now ready to accept program changes.
  8. Press UNLOCK once to command the vehicle security module to toggle the autolock/relock feature OFF.
  9. Press LOCK once to enter the command.
  10. Verify that the horn chirps one time. There should only be one chirp indicating that the autolock/relock feature has been disabled. If one chirp is heard followed by a longer sound of the horn, the autolock/relock feature has just been enabled. Return to Step 10.
  11. Turn the key to the OFF position to exit the enable/disable mode.
scientia non olet · About LEMON Manuals