LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 705 (Seat System -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Seat Armrest - Excursion, Second Row, 60 Percent >> Removing and installing

Removing and installing

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat. Refer to REAR SEAT - EXCURSION, SECOND ROW .
  2. Remove the access covers.
    Fig 1: Removing Access Covers
    G02773823Courtesy of FORD MOTOR CO.
  3. Remove the screws.
    Fig 2: Removing Screws
    G02773824Courtesy of FORD MOTOR CO.
  4. Remove the bolts from both sides of the armrest.
    Fig 3: Removing Bolts From Both Sides Of Armrest
    G02773825Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
  6. Make sure the safety belt and the belt buckle are routed through the access hole in the seat cushion.
    Fig 4: Identifying Safety Belt And Belt Buckle
    G02773826Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals