LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 705 (Seat System -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Rear Seat - Excursion, Second Row >> Installation

Rear Seat - Excursion, Second Row: Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the 40 percent seat, install the left and right front bolts, then position the seat forward and install the rear bolts.
    2. NOTE: When installing the 60 percent seat, be sure to position the safety belt and buckle through the cavity in the seat cushion before tightening the bolts.
    • Make sure the safety belt is not twisted prior to installation.
  2. On the 60 percent seat, install the right front bolt, then the left front bolt.
  3. Install trim covers and pin-type retainers.
  4. Position the seat forward and install the rear bolts.
    • Adjust the seat to the full forward and rearward positions a few times to assure safety belt and buckle accessibility.
  5. Check the active restraint system for correct operation. Refer to SAFETY BELT SYSTEM .
scientia non olet · About LEMON Manuals