Rear Seat Cushion - Third Row: Disassembly

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disassemble the third row seat. Refer to REAR SEAT BACKREST - EXCURSION, THIRD ROW .
Remove the seat bottom cover.
1. Remove the four pin-type retainers.
2. Release the eight J-clips.
  
  Fig 1: Removing Seat Bottom Cover
  Courtesy of FORD MOTOR CO.
Remove the seat cushion trim cover and foam pad from the seat cushion frame.
- Unhook the J-clips.
  
  Fig 2: Unhooking J-Clips
  Courtesy of FORD MOTOR CO.
Position the upholstery back and remove the hog rings.

Fig 3: Removing Hog Rings
Courtesy of FORD MOTOR CO.
Remove the seat cushion trim cover from the seat cushion foam pad.
Remove the safety belts.
- Using the special tool, remove the two bolts.
  
  Fig 4: Locating Bolts
  Courtesy of FORD MOTOR CO.
Remove the seat riser.
- Remove the nuts.
  
  Fig 5: Removing Seat Riser
  Courtesy of FORD MOTOR CO.
Remove the four seat rollers.
1. Remove the four bolts.
2. Remove the four wheels.
  
  Fig 6: Removing Seat Rollers
  Courtesy of FORD MOTOR CO.