Rear Seat Cushion - Third Row: Assembly

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The front wheels are larger than the rear wheels.

Install the four seat rollers.
1. Position the four rollers.
2. Install the four bolts.
  
  Fig 1: Installing Seat Rollers
  Courtesy of FORD MOTOR CO.
Install the seat riser.
- Install the nuts.
  
  Fig 2: Installing Seat Riser Nuts
  Courtesy of FORD MOTOR CO.
Install the safety belts.
- Using the special tool, install the bolts.
  
  Fig 3: Installing Safety Belts
  Courtesy of FORD MOTOR CO.
Install the seat cushion trim cover onto the seat cushion foam pad.
Install the hog rings.

Fig 4: Installing Hog Rings
Courtesy of FORD MOTOR CO.
Install the seat cushion frame into the seat cushion trim cover and foam pad.
- Connect the J-clips.
  
  Fig 5: Connecting J-Clips
  Courtesy of FORD MOTOR CO.
Install the seat bottom cover.
1. Connect the J-clips.
2. Install the four pin-type retainers.
  
  Fig 6: Installing Pin-Type Retainers
  Courtesy of FORD MOTOR CO.
Assemble the third row seat. Refer to REAR SEAT BACKREST - EXCURSION, THIRD ROW .