Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the passive anti-theft system (PATS) module electrical connector.

Fig 1: Disconnecting Passive Anti-Theft System (Pats) Module Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the PATS module by pulling it up off the two locator tabs on the bracket.

Fig 2: Removing Pats Module
Courtesy of FORD MOTOR CO.

CAUTION: Once the new PATS module is installed, it is necessary to configure the module. Refer to MODULE CONFIGURATION .

NOTE: Prior to starting the vehicle, check for PATS DTCs. If DTCs are retrieved, carry out the appropriate pinpoint test.

NOTE: When the PATS module is replaced, both ignition keys must be relearned and stored in memory. Insert each key in the ignition and turn to RUN for automatic programming.

To install, reverse the removal procedure.