LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Exterior Lighting System -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Photocell >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Remove the photocell assembly.
    • Disconnect the electrical connector.
      Fig 1: Disconnecting Electrical Connector
      G02777888Courtesy of FORD MOTOR CO.
  3. NOTE: Take care not to break the retaining tabs.
    Fig 2: Removing Photocell
    G02777889Courtesy of FORD MOTOR CO.
  4. Disengage the locking tabs and remove the photocell.
  5. To install, reverse the removal procedure.