Diagnostic Aids

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

Perform this test when directed by QUICK TEST. BARO sensor is part of PCM and is not serviced separately. If BARO sensor is faulty, PCM must be replaced. BARO sensor functions are as follows:

Timing Control

The BARO signal affects injection timing and fuel quantity to optimize engine operation and control smoke throughout all altitude conditions.

Glow Plug Control

The BARO signal is one of the variables used to calculate glow plug ON time. At higher altitudes, glow plug ON time is increased to reduce start-up smoke.

Detection & Management

A BARO signal that is detected out of range (high or low) by PCM will cause PCM to ignore BARO signal and use Manifold Absolute Pressure (MAP) signal generated at low idle as an indication of barometric pressure.