Fuel Line Fittings - Push Connect: Disconnect

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related component. Highly flammable mixtures are always present and may be ignited, resulting in possible personal injury.

WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before servicing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.

Relieve the fuel pressure. Refer to FUEL SYSTEM PRESSURE RELEASE - GASOLINE ENGINES or FUEL SYSTEM PRESSURE RELEASE - DIESEL ENGINES .
Disconnect the safety clip from the male hose.

Fig 1: Disconnecting Safety Clip From Male Hose
Courtesy of FORD MOTOR CO.
Install the fuel line disconnect tool and push into the fitting.

Fig 2: Installing Fuel Line Disconnect Tool
Courtesy of FORD MOTOR CO.
Separate the fittings.
- Inspect for damage.
- Clean the fittings.
  
  Fig 3: Cleaning Fittings
  Courtesy of FORD MOTOR CO.